Specification for Garages
Doors
(1/2") 12mm tongued and grooved door lining on (4" x 1 1/2") 95mm x 33mm door bars,
strongly braced and hung on three pairs of (18") 450mm galvanised
T-hinges. Timber garage door openings are (7'-0") 2.1m approximately.
Metal Up-and-Over doors are available in 2.1m at an additional cost.
8'-0" doors also available. Alternatively a single timber door can be
supplied instead of double garage doors. Lock and key included
Walls
(1/2") 12mm tongue and grooved weatherboard with (3" x 1 1/2") 70mm x 33mm dressed
framing.
Ventilators
As required by Local Authority Regulations, these are fitted front and rear.
Windows
Two fitted on side, glass fitted.
Finish
All buildings can be treated with a coat of Holly Green,
Red Cedar, Dark Brown, Golden Brown.
Assembly
All units are bolted together complete with barge boards,
finials, etc., all supplied and fitted. All ironmongery and
exterior nails are galvanised, or zinc plated.
Foundations
Concrete base should be built as instructed and must be square
and level (see foundation diagram). Provided the ground
is
cleared and level, a timber surround can be laid for the
garage to sit on at an additional charge. Timber floor (optional)
is constructed from (3" x 2") 75mm x 50mm Tanalised joists covered
by (3/4") 19mm nominal tongue and grooved flooring. If timber floor is
required, we can supply (4" x 2") 100mm x 50mm tanalised battens
to support it over the entire length of the garage - again provided
the ground is cleared and level. Please ask about this optional service
GARAGE BASE
To allow the bottom weatherboard on the garage to overlap the foundation,
the maximum foundation size should be
3" less in width and
3" less in length than the size of the garage
The level of the foundation should be 1" higher than the runway
level to accommodate the overlap at the bottom of the door (fig.2).
Please note that the customer is responsible for fixing down and sealing
the garage to the foundations after erection.
We cannot be held responsible for storm damage.
Payment must be made to our fitter on completion.